Automatic COBRA Instrukcja Instalacji Pobierz pdf (Strona 7)

Page 7

OPERATING CONTROLS

4. DISPLAY

General Display Codes

dcc ro7 Flashes on the display once the opener powers up (dc opener chain drive,

ﬁ rmware revision o7)

r Reset limits, Door has not been set to its limits

P Flashes on the display, door is stationary and in Pet Mode

O Flashes on the display, door is stationary and not at the close, open or pet posi

tions

O Door is currently Open

C Door is currently Closed

E On the last operation an obstruction was detected

t Will only ﬂ ash brieﬂ y before going to E. Indicates Hall Effect sensor timeout

d Will only ﬂ ash brieﬂ y before going to E. Indicates standard door obstruction

S Indicates the door is probably closed but being obstructed, E.g. snow around the

door

b The opto beam is indicating an obstruction.

H The door has been detected as too heavy

LoC Flashes on the display, door is on vacation lock mode.

EOS Flashes on the display, door was forced open via BMS. Power must be removed to

reset this.

o Flashes on the display, the close position has been set, it is ready to move the

door to open position.

. Unit is in power save mode

5. INSTALL BUTTON

Pressing the INSTALL button momentarily scrolls through the modes in the following order.

The appropriate letter will be shown on the display.

Limits. Set the Limits.

2) Force. Set the Force Margin.

3) Pet. Set the Pet mode

4) Autoclose. Set the Autoclose Time.

5) Courtesy Time. Set the Courtesy Light Time.

Pressing the LEARN button at any time or waiting for 10 seconds exits this menu.

6. TERMINAL P1

Alarm/Status(ALM)

Pressing the transmitter button associated with the Alarm function, the alarm terminal will

enable the output to pulse for a preset period so that an external alarm may be toggled on/off.

If there are no transmitter buttons memorised for the security alarm this output will function as

a door Status output. When the door is open or partially open the output will be on. When the

door is closed the output will be off. When the door is moving the output will toggle at the rate

of 2Hz.

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Brak uwag

Automatic COBRA Instrukcja Instalacji Strona 7